summaryrefslogtreecommitdiff
path: root/platforms/chibios/drivers/vendor
diff options
context:
space:
mode:
Diffstat (limited to 'platforms/chibios/drivers/vendor')
-rw-r--r--platforms/chibios/drivers/vendor/RP/RP2040/serial_vendor.c17
1 files changed, 2 insertions, 15 deletions
diff --git a/platforms/chibios/drivers/vendor/RP/RP2040/serial_vendor.c b/platforms/chibios/drivers/vendor/RP/RP2040/serial_vendor.c
index 764764b3f9..afd7e65ad8 100644
--- a/platforms/chibios/drivers/vendor/RP/RP2040/serial_vendor.c
+++ b/platforms/chibios/drivers/vendor/RP/RP2040/serial_vendor.c
@@ -140,9 +140,8 @@ void pio_serve_interrupt(void) {
// strength is chosen because the transmitting side must still be able to drive
// the signal low. With this configuration the rise times are fast enough and
// the generated low level with 360mV will generate a logical zero.
-static inline void enter_rx_state(void) {
+static void __no_inline_not_in_flash_func(enter_rx_state)(void) {
osalSysLock();
- nvicEnableVector(RP_USBCTRL_IRQ_NUMBER, RP_IRQ_USB0_PRIORITY);
// Wait for the transmitting state machines FIFO to run empty. At this point
// the last byte has been pulled from the transmitting state machines FIFO
// into the output shift register. We have to wait a tiny bit more until
@@ -162,11 +161,8 @@ static inline void enter_rx_state(void) {
osalSysUnlock();
}
-static inline void leave_rx_state(void) {
+static void __no_inline_not_in_flash_func(leave_rx_state)(void) {
osalSysLock();
- // We don't want to be interrupted by frequent (1KHz) USB interrupts while
- // doing our timing critical sending operation.
- nvicDisableVector(RP_USBCTRL_IRQ_NUMBER);
// In Half-duplex operation the tx pin dual-functions as sender and
// receiver. To not receive the data we will send, we disable the receiving
// state machine.
@@ -198,11 +194,6 @@ static inline msg_t sync_tx(sysinterval_t timeout) {
msg_t msg = MSG_OK;
osalSysLock();
while (pio_sm_is_tx_fifo_full(pio, tx_state_machine)) {
-#if !defined(SERIAL_USART_FULL_DUPLEX)
- // Enable USB interrupts again, because we might sleep for a long time
- // here and don't want to be disconnected from the host.
- nvicEnableVector(RP_USBCTRL_IRQ_NUMBER, RP_IRQ_USB0_PRIORITY);
-#endif
pio_set_irq0_source_enabled(pio, pis_sm0_tx_fifo_not_full + tx_state_machine, true);
msg = osalThreadSuspendTimeoutS(&tx_thread, timeout);
if (msg < MSG_OK) {
@@ -210,10 +201,6 @@ static inline msg_t sync_tx(sysinterval_t timeout) {
break;
}
}
-#if !defined(SERIAL_USART_FULL_DUPLEX)
- // Entering timing critical territory again.
- nvicDisableVector(RP_USBCTRL_IRQ_NUMBER);
-#endif
osalSysUnlock();
return msg;
}